https://wiki.wingeav.de/index.php?action=history&feed=atom&title=Cisco_passwordCisco password - Versionsgeschichte2026-04-17T17:51:24ZVersionsgeschichte dieser Seite in MyWikiMediaWiki 1.45.3https://wiki.wingeav.de/index.php?title=Cisco_password&diff=137&oldid=prevRueling: Die Seite wurde neu angelegt: „Reset Password Step 1. Attach a terminal or PC to the console port of the UC500 Series Device. Step 2. Use the power switch in order to turn off the UC500 devic…“2015-03-10T13:49:22Z<p>Die Seite wurde neu angelegt: „Reset Password Step 1. Attach a terminal or PC to the console port of the UC500 Series Device. Step 2. Use the power switch in order to turn off the UC500 devic…“</p>
<p><b>Neue Seite</b></p><div>Reset Password<br />
<br />
Step 1. Attach a terminal or PC to the console port of the UC500 Series Device.<br />
<br />
Step 2. Use the power switch in order to turn off the UC500 device, then turn the device back on.<br />
<br />
Step 3. Immediately begin to repeatedly press the break sequence, in most scenarios this is CTRL+Break, for the device in order to boot the device into ROMMON mode.<br />
<br />
<br />
<br />
Step 4. Enter confreg 0x2142 at the rommon 1> prompt. This step bypasses the startup config where the passwords are stored at next boot up.<br />
<br />
Note: rommon — It is a Rom on mode is a default configuration mode to reset device to its factory default settings <br />
<br />
<br />
<br />
Step 5. Enter reset at the rommon 2> prompt. The UC500 reboots but ignores the saved configuration.<br />
<br />
<br />
<br />
Step 6. When the UC500 returns from the reset, enter No if asked to enter the initial configuration dialog.<br />
<br />
<br />
<br />
Step 7. Enter enable to enter the privileged mode of the UC500 device.<br />
<br />
<br />
<br />
Step 8. Enter copy startup-config running-config to save the configuration once again. This command saves the start up configuration data to the non-volatile RAM where the running configuration data is stored.<br />
<br />
<br />
<br />
Step 9. Enter configure terminal to enter the global configuration mode of the UC500 device.<br />
<br />
<br />
<br />
Step 10. Enter the new password. The following commands instruct how to change the different login information on the device.<br />
<br />
• To enable the password enter enable secret. This encrypts the password, it will be visible as the encrypted version of the original password in the running configuration. <br />
<br />
• To device Access Password enter username secret.<br />
<br />
<br />
<br />
Step 11. Reset the configuration register to its previous value by entering config-register 0x2102 in the configuration mode of the UC500 device.<br />
<br />
Step 12. Save these changes with the use of the write memory command.</div>Rueling